Gray cable manufacturers STC and we met, and today to give you to share is "finished IDC gray cable crimping method at both ends." Speaking of crimping methods Many customers know some, but there are a lot of people are not completely understand. In the communication often because of this crimping method here to delay a lot of time. In order not to go wrong, and often also need to provide samples to determine the direction of the right after. Come again to do IDC cable. So delay the delay time, but also a waste of a certain cost. Then the finished product IDC gray cable at both ends in the end is how it? Here we bring one by one ...
(A) the same direction, the same bump [conventional pressure method]
The two IDC crimps are oriented in the same direction, and the direction of the bumps is the same. Triangle of the red side of the conventional pressure method is also known as one to one pressure method, eighty percent of the customers are using this pressure method! 6-34P can be used automatic pressing machine crimping, as shown in Figure A1: the top one for the three-piece, the following one for the non-buckle two-piece! In the three-piece direction of the bumps prevail!
(B) the same direction, bumps back
Two IDC crimping heads in the same direction, bumps in the opposite direction. As shown in Figure A2: the above one for the three-piece, the following one for the non-buckle two-piece! We will ask how the bumps assured how not the same! Two-piece buckle buckle is the three-piece direction! Routine is to do three-piece, so here is the three-piece direction of the bumps prevail!
The two IDC crimps are oriented in the same direction, with the bumps facing each other. As shown in Figure A3: the above one for the three-piece, the following one is not buckle the two-piece! In the three-piece direction of the bumps prevail! Need two pieces that should pay attention to!
The two IDC crimps are oriented in the opposite direction, the bumps are in the same direction. As shown in Figure B1: the above one for the three-piece, the following one for the two-button without buckle! Routine is to do three-piece, so here is the three-piece direction of the bumps prevail!
(E) a positive and negative, bumps back
Two IDC crimping the opposite direction, the direction of the bumps, that is, the opposite meaning. As shown in Figure B2: the above one for the three-piece, the following one is not buckle the two-piece! Routine is to do three-piece, so here is the three-piece direction of the bumps prevail!
(Six) a positive and negative, bumps relative
The two IDC crimps are oriented in opposite directions, the bumps are oriented in opposite directions. As shown in Figure B3: the above one for the three-piece, the following one for the non-buckle of the two-piece! Routine is to do three-piece, so here is the three-piece direction of the bumps prevail!